Stacked On Track Summer Cookout - North Course requirements on Jun 16, 2019 (176081) | MotorsportReg.com

This event is over! Can we show you some more events nearby?

Stacked On Track Summer Cookout - North Course

Event Requirements

Registration closed June 15, 2019 6:00 PM at 2019-06-15T15:00:00-0700 Registration ends June 15, 2019 6:00 PM at 2019-06-15T15:00:00-0700 Registration opens April 25, 2019 10:00 PM at 2019-04-25T19:00:00-0700 Registration runs from April 25, 2019 10:00 PM to June 15, 2019 6:00 PM

HPDE:

  1. All drivers must attend the Driver’s meeting, which will be held 30 minutes before the start of each event. Ex. If an event starts at 10:00am the drivers meeting will begin at 9:30am

  2. All drivers must possess a valid driver’s license. 

  3. Driver’s must wear long pants and closed toe shoes.

  4. All drivers must have and wear a working seatbelt!

  5. A helmet is required. Must be SA2010 or SA2015, open faced helmets are allowed. All helmets must have a working chin strap and must be used.

  6. Road Speed is 10 mph in all areas off the track

  7. No trucks, vans, or SUVs are allowed to drift without approval. Any soft-top convertibles must have rollover protection. Stacked reserves the right to refuse track use to any vehicle deemed unsafe for participation.

Section II: Vehicle Requirements

  1. Vehicle inspection will be conducted at the beginning of every event. Tech Inspection will be conducted before the driver’s meeting. Any car deemed unsafe will not be able to participate until all safety requirements are met.

  2. Brakes, Drive train, chassis, and suspension will all be inspected for safety.

  3. Fire Extinguishers are Highly Recommended for all events. They must be mounted properly (no zip ties!) and must be within reach of the driver WHILE they are fastened into their seat. Minimum 2Lb rated 

  4. Everything Loose inside your vehicle must be removed including floor mats, cell phones, baby car seats, sunglasses, tires and all other types of random junk

  5. ABSOLUTLEY no fluids can be leaking out of your car.

  6. Battery must be securely tied down with proper hardware. No duct tape or wood blocks, no bungie ties rope or zip ties. If the battery box is located in the drivers compartment then it must be sealed – non venting. If it is not sealed then it must vent to the exterior of the car.

  7. All suspension bushings and ball joints must be in good condition and must not have any play or clunking.

  8. All participants’ cars must have all lug nuts present on both wheels and spacers.

  9. A heat shield is required. This heat shield must protect the brake and clutch master cylinder and is only required for cars with exhaust manifolds on the same side as the brake/clutch master cylinders.

  10. Coolant overflow is required. Yes, it can be a bottle but the hoses must be properly fastened to the tank.

  11. Convertibles: All convertibles MUST have a roll bar for all track events, skid pad is the only exception. No junk roll bars either. Please contact us with any questions about roll bars being accepted

  12. Brake lights must be operational

  13. Tow hooks are required both front and rear and must be highly visible and/or their location clearly marked. Soft straps are not required but recommended for ease of use.

Section III Harnesses and Seats:

  1. Harnesses must be mounted properly. Harness in-date are recommended, expired harnesses must be in good shape with no rips or tears.

  2. Harnesses must be mounted using proper hardware. When using eye bolts which go though the floor, large fender washers must be used. Harness shoulder straps must be mounted to a roll cage or separate harness bar and should not be outside of 20* of horizontal. The seat cannot be used as a guide for the harness. Harness mounting points must be attached to the chassis or roll cage/harness bar, not to the seat or seat rails.

  3. If car does not have a roll cage, a harness bar can be used to mount the shoulder belts when using a 4, 5 or 6-point harness. 4, 5 or 6 point harnesss is required for any vehicles equipped with a roll cage, minimum of 5 point is recommended.

  4. Please refer to manufacture specs for proper installation and maintenance procedures.

  5. If stock seats are used, oem seatbelt must be used. Harnesses are not permitted for use with seats which do not have provisions for such.

  6. If race seats are intended to be used with stock seat belt, the lap belt part of the seat belt must pass through the holes in the sides of the seat

Registration closed June 15, 2019 6:00 PM at 2019-06-15T15:00:00-0700
Registration opens April 25, 2019 10:00 PM at 2019-04-25T19:00:00-0700

To register, select one of the following options and continue...

Sign in Create free account