Frost on the Pumpkin - November 2008
Event Requirements
Registration closed October 27, 2008 11:59 PM at 2008-10-27T21:59:00-0700 Registration ends October 27, 2008 11:59 PM at 2008-10-27T21:59:00-0700 Registration opens June 16, 2008 12:00 AM at 2008-06-15T22:00:00-0700 Registration runs from June 16, 2008 12:00 AM to October 27, 2008 11:59 PM

October 31 to November 2, 2008 Driver's School
Sponsored By:
THE INFORMATION ON THIS PAGE HAS BEEN UPDATED
PLEASE READ IT CAREFULLY NO MATTER YOUR LEVEL OF EXPERIENCE!
These requirements may significantly affect your ability to participate in our event. Reading and complying with these requirements will avoid future issues or disappointment if we are forced to decline your application.
A Snell 2000 or newer certified helmet is required; a limited number of loaners are available
All drivers must be licensed drivers 18 years of age or older. All participants must be current members of the BMW Car Club of America. Online and printable paper membership application forms are at: stage.bmwcca.org/index.php
CONVERTIBLES
Convertibles must have an approved aftermarket roll bar installed. The roll bar must be high enough that the driver's helmet clears a line between the top of the roll bar and the top of the windshield by one inch or more. Factory roll hoops or bars typically don't meet this requirement. Self deploying roll hoops are not considered to meet this requirement. Properly installed 4, 5 or 6 point harnesses are also required. (See 4,5, and 6 POINT BELTS below for more information.) The convertible top must be in place.
Please be aware that most instructors will not instruct in a convertible. If you have a convertible complying with our requirements, we will make all reasonable effort to identify an instructor willing to ride in a convertible, but can not guarantee that we will be successful.
4, 5 and 6 POINT BELTS
All aftermarket or racing belts must be installed according to the manufacturer’s instruction. Please note: shoulder belts must pass through, not around any seat headrest and anti-submarine straps must be routed through a center hole in the seat designed for that purpose. This requires that the seats be desgined to accept harnesses. Stock seats modified by cutting holes in the material are not acceptable. Shoulder belts must pass through the seat’s head restraint for the harnesses to be effective. Seats with integral head rests must have holes designed for shoulder belt routing. The use of a sternum strap will not help meet this requirement. A roll bar or cage is not required, but it is highly recommended.
No SUV's, trucks or motorcycles are allowed.
Contact the event registrar for more information or with questions.